Table of Contents
Advertisement
OPERATION
Datum
To set the datum at the tool's current position:
•
Position the workpiece on the table. Move the table until the tool is
centered on the edge of the workpiece at the location where you
would like to establish the datum.
•
Using the
ABS/INCR
•
Press the X-axis
position as the datum. Repeat for the Y- and Z-axes.
To set the datum using an offset:
•
Using the
ABS/INCR
check that the proper measurement (inch or mm) is selected.
•
Move the tool to a known point, i.e. the outside diameter of the
workpiece or the face of the workpiece.
•
Press the
ZERO
dimension.
•
Using the keypad, enter the distance from your tool's current
location to the point you want to establish as the datum. Include a
decimal point (.) and minus (-) sign when necessary.
•
Press the
ZERO
the DRO display.
14
key, select the absolute (ABS) mode.
key twice to establish the current X-axis
ZERO
key, select the absolute (ABS) mode. Also
key for the axis (X, Y or Z) you are entering a
key for another axis, or press
to return to
ENTER
Reference Manual
100S
Advertisement
Table of Contents
