Running A Bolthole Pattern - ACU-RITE 100S Reference Manual

Running a Bolthole Pattern

When you run a bolthole pattern,
start with the first hole. It will display "Hole 1," and then the distance
to the hole from your tool's current position. Move the table until it
reaches 0, 0. After you've drilled the hole, press the
again, and "Hole 2" will appear. Move the table to "0," drill the hole
and continue with the rest of the pattern. If you want to start at a differ-
ent place in the pattern, press
hole you want to begin with.
Notice that the system automatically switches to the incremental mode
whenever you run a pattern. That's because the system is using incre-
mental presets (pg. 18) to measure from one hole to another. As with
any preset, you can find the current hole's location by moving the table
until the displays for both the X- and Y-axes read "0."
After you've completed the operation, you may either keep the readout
in the incremental mode or press the
absolute measurements.
To run a bolthole pattern:
•
Press the
BOLT USE
appear on the X-axis display. The number of
the first hole to be milled will appear on the
Y-axis display. (To select a different hole,
refer to the note on the next page.)
will display the distance to the hole you've chosen.
• 100S
Move the table until the X- and Y-axes both read "0." Drill the first
hole.
• Press the
BOLT USE
Y-axes read "0." Drill the second hole. Repeat the procedure for
each hole in the pattern.
Note: To select a different hole in the pattern, press the
key and immediately press the number of the hole you want to
mill. Press "2" on the keypad for Hole 2, "3" for Hole 3, etc.
The holes are numbered counter-clockwise from the start angle.
You can also scroll through the series of holes by pressing the
BOLT USE
Reference Manual
100S
100S
BOLT USE
ABS/INCR
key. "HOLE" will
key again. Move the table until the X- and
key repeatedly.
OPERATION
always assumes that you want to
BOLT USE
followed by the number of the
key to switch to
BOLT USE
key
25