Bolthole Patterns
Creating a Bolthole Pattern
A bolthole pattern is defined by its
number of holes (up to 99), center
point, radius, and start angle.
will automatically position "Hole
100S
1" at the start angle and space the
holes equally throughout the pattern.
To create a bolthole pattern:
1. Press the
BOLT DEF
will appear on the X-axis display.
2. Enter the number of holes (1-99) in the
pattern. Press the
3. Press the
ENTER
will appear , and then a flashing dash will
appear on the X- and Y-axes.
4. Press the
key. Using the keypad,
X
define the center point of the bolthole
pattern on the X-axis. Use a decimal
point and minus (-) sign when neces-
sary.
5. Press
.
ENTER
Reference Manual
100S
key. "HOLES"
key.
ENTER
key again. "Center"
OPERATION
Hole 1
23