Rack Rear: Attaching The San Volume Controller 2145-Cf8 Cable-Management; Support Arm; Rack Rear: Installing The San Volume Controller 2145-Cf8 Cable-Management Stop; Bracket - IBM 2145-CF8 Hardware Installation Manual

2. At the rear of the rack, connect one end of the support arm, as shown by 1 in
Figure 24, to the same slide rail to which you plan to attach the
cable-management arm so that you can swing the other end of the support arm
2 toward the rack.
2
Figure 24. Rack rear: Attaching the SAN Volume Controller 2145-CF8 cable-management

support arm

3. Install the L-shaped cable-management stop bracket, as shown by 1 in
Figure 25 on the unattached end of the support arm. Turn the bracket 2 to
secure it to the support arm.
Figure 25. Rack rear: Installing the SAN Volume Controller 2145-CF8 cable-management
stop bracket
4. To attach the other side of the support arm to the backside of the slide rail, pull
the pin out, as shown by 1 in Figure 26 on page 28, and then slide the
bracket 2 into the slide rail.
2
1
2
1
Chapter 2. Installing the SAN Volume Controller 2145-CF8 hardware
27