Emerson Rosemount Quick Install Manual page 2

Quick Install Guide
1 Safety
WARNING
• Failure to follow these installation guidelines could result in serious injury
or death.
• Installation and servicing instructions are for use by qualified personnel
only. Do not perform any servicing other than that contained in the
operating instructions, unless qualified.
• Potential electrostatic charging hazard: Rosemount Magnetic flow
meters ordered with non-standard paint options or non-metallic labels
may be subject to electrostatic discharge. To avoid electrostatic charge
build-up, do not rub the flow meter with a dry cloth or clean with
solvents.
• Verify that the operating environment of the sensor and transmitter is
consistent with the appropriate Agency Approval.
• If installed in an explosive atmosphere, verify that the device certification
and installation techniques are suitable for that particular environment.
• To prevent ignition of flammable or combustible atmosphere,
disconnect power before servicing circuits.
• Explosion hazard: Do not disconnect equipment when a flammable or
combustible atmosphere is present.
• Follow national, local, and plant standards to properly earth ground the
transmitter and sensor. The earth ground must be separate from the
process reference ground.
• Shock hazard: Shut off power before servicing. Do not operate without
power compartment cover.
2
™
Rosemount MS Slurry Magnetic Flow Meter Sensor
November 2019