ACCESSORY
Application:
Assembly:
HYDRAULIC LEVELLING BAR
Your Compact can be fitted with a hydraulic levelling bar in front of the
roller rings. This makes a very effective implement for breaking up clods and
levelling and packing the soil after ploughing.
Hitch the roller to a tractor and park it in the transport position on firm,
level ground. An approved lifting tackle must be available. Maximum
weight 250 kg.
See fig. 7.
Raise the bracket (position 1) for the central section under the drawbar and
secure it with the three clamp plates. Weight 65 kg. Tighten them only
slightly.
Bolt on and clamp the hydraulic unit (position 2).
Fig. 7:
Open up the roller into the operating position (see above). Run it forwards
and backwards a few metres until the side sections are properly positioned.
Fit the innermost suspension for the side sections (weight 38 kg),then attach
the outermost suspension (weight 35 kg). Note the distance A between the
suspensions in fig. 8, (A=120 cm). The sidesection of the levelling bar
must be fitted tightly, not allowing it to move from side to side in the
suspensions.
15