Dangers Due To Incorrect Use; Crushing Hazards - HALDER EH 22350 Series Operating Instructions Manual

2 Safety
2.5 Special danger warnings / residual dangers
2.5.4

Dangers due to incorrect use

DANGER
2.5.5

Crushing hazards

WARNING
When working with the lifting pin there is a danger due to incorrect
use!
A failure to observe this will result in death or serious injury!
– Note that contamination (e.g. grinding sludge, oil and emission deposits,
dust, etc.) can impair the function of the lifting pins.
– Never use the lifting pins as a protective device or safety function.
– Never use the lifting pins as a traction element.
– Prepare the installation sketch according to the specifications of the
company Erwin Halder KG.
– Never use the lifting pins without locking.
–
Never use the lifting pins with constantly rotating loads.
– Never use the lifting pins to lift, hold or carry people,
– Only use approved location holes.
– Before each use, check the lifting pins for visible defects (e.g.
deformations, breaks, cracks, damage, missing balls, corrosion, function
of the release).
– During use or at work always wear the personal protective equipment
necessary for the work in question (protective clothing, protective
gloves, safety helmet for overhead use, and safety shoes).
– Never colour-code the lifting pins (especially red), to avoid confusion
with high-strength anchor points.
– Note that the load values only apply to lifting in a steel hole.
Risk of injury due to crushing!
Serious injuries may occur during operation!
– Never use the lifting pins with defective components. Never put built-in
components out of operation.
–
Make sure that the lifting pins are properly fastened.
– Make sure that no limbs of your own or other persons are under
suspended loads.
21