Special Danger Warnings / Residual Dangers; Symbols Used On The Lifting Accessory; Dangers Due To Falling Loads; Dangers From Hot Surfaces - HALDER EH 22350 Series Operating Instructions Manual

2 Safety

2.5 Special danger warnings / residual dangers

2.5 Special danger warnings / residual dangers
2.5.1

Symbols used on the lifting accessory

Keep all safety and danger information on the lifting pin in a legible condition.
Renew this information as necessary.
2.5.2

Dangers due to falling loads

WARNING
2.5.3

Dangers from hot surfaces

WARNING
Observe the original operating instructions
This symbol indicates that the original operating instructions must be
observed.
CE marking
The CE marking on the product is the manufacturer's declaration that the
product complies with the essential requirements of the relevant European
health, safety and environmental protection legislation.
Risk of injury from loads falling down when opening the lifting pin!
A failure to observe this can result in death or serious injury!
– Make sure that the locking press button can never be actuated under
load.
– Please note that during use an opening of the lifting pin must be ruled
out by suitable countermeasures.
– During use or at work always wear the protective equipment necessary
for the work in question.
Burning danger due to hot surfaces!
Non-compliance may result in minor injuries!
Hot loads can transfer heat to the lifting pins!
– Wear protective gloves when working with hot loads.
20