HALDER EH 22350 Series Operating Instructions Manual page 14

2 Safety
2.1 Intended use
The intended standard method of use of the lifting pin is operation by one person, and
they may only be operated by instructed specialist personnel. The lifting pin may only be
used within the scope of its technical data. The specified maximum technological data
must not be exceeded. The load values F1, F2 and F3 apply to lifting in a steel hole. The
field of application of the lifting pin is the area of industry. The lifting pin are not intended
for different modes of operation, as this is a manual tool. Lifting pins are not intended for
any other use than the use listed here; other uses would be considered improper use. In
particular, it is prohibited
– to subsequently colour-code the lifting pins (especially in red), to avoid any mistaking
of them with high-strength anchor points,
–
to exceed the maximum load of the lifting pins (see "3.3 Technical data"),
– to use the lifting pins after exceeding the maximum permissible load cycles (see "3.3
Technical data"). After exceeding the maximum permissible load cycles (see "3.3
Technical data"), the lifting pins must be permanently taken out of operation,
– to use the lifting pins as protective device or safety function,
–
to use the lifting pins as a traction element,
– not to produce the installation sketch according to the specifications of the company
Erwin Halder KG,
– to use defective or unsuitable accessories,
– to use the lifting pins if the functional components are deactivated, manipulated or
defective,
– to use the lifting pins while untrained persons are in the danger zone,
– to use the lifting pins if they are not ready for operation or have been modified,
– to use the lifting pins without instruction.
– to use the lifting pins only inserted, without using locking,
– to use the lifting pins for constantly rotating loads,
–
to use the lifting pins for lifting, holding or carrying persons,
– to actuate the locking press button under load,
– to place objects on the lifting pin. Remove all objects that are on the lifting pin.
14