2 Safety
2.5 Special danger warnings / residual dangers
2.5.4
Dangers due to incorrect use
DANGER
2.5.5
Crushing hazards
WARNING
When working with the threaded lifting pins there is a danger due to
incorrect use!
A failure to observe this will result in death or serious injury!
Note that contamination (e.g. grinding sludge, oil and emission deposits,
–
dust, etc.) can impair the function of the threaded lifting pins.
Never use the threaded lifting pins as a protective device or safety
–
function.
Never use the threaded lifting pins as a pulling element.
–
Prepare the installation sketch according to the specifications of the
–
company Erwin Halder KG.
Never use the threaded lifting pins without locking.
–
Insert or turn the threaded lifting pins completely into a thread that is true
–
to gauge and make sure that it rests completely on the bearing surface
(on the 30° bevel threaded lifting pins for centre holes according to DIN
332).
Never use the threaded lifting pins with constantly rotating loads.
–
Never use the threaded lifting pins to lift, hold or carry people,
–
Before each use, check the threaded lifting pins for visible defects (e.g.
–
deformations, breaks, cracks, damage, missing threaded elements,
corrosion, function of the release).
During use or at work always wear the personal protective equipment
–
necessary for the work in question (protective clothing, protective
gloves, safety helmet, and for overhead use, safety shoes).
Never colour-code the threaded lifting pins (especially red), to avoid
–
confusion with high-strength anchor points.
Note that the load values only apply to lifting in a steel receptacle.
–
Risk of injury due to crushing!
Serious injuries may occur during operation!
Never operate the threaded lifting pins with defective components.
–
Never put built-in safety components out of operation.
Make sure that the threaded lifting pins are properly fastened.
–
Make sure that no limbs of your own or other persons are under
–
suspended loads.
22