Safety; Intended Use - HALDER EH 22350 Series Operating Instructions Manual

Lifting pin

Hide thumbs Also See for EH 22350 Series:

Table of Contents

Safety

WARNING

2.1

The operational safety of the lifting pin is only guaranteed if they are used as intended.

The lifting pins are intended exclusively as lifting/hoisting accessory for lifting and holding

individual loads. The lifting pins are not suitable for rotating the load. Damaged lifting pins

can endanger lives. Before each use, check the lifting pin for visible defects (e.g.

deformations, breaks, cracks, damage, missing balls, corrosion, function of the release).

When inserting a lifting pin, the rotation of the load must be prevented. Contamination

(e.g. grinding sludge, oil and emission deposits, dust, etc.) can impair the function of the

lifting pin. Damaged lifting pins must be immediately withdrawn from further use. To

release the balls, press in the press button (A). By releasing the press button (A) the balls

are locked again.

Attention: The press button (A) is locked when it is sprung back to its original position by

the spring force. The press button must not be actuated under load! Before operation, the

lifting pins must be checked for accidental or unintentional actuation of the press button to

release the lifting pin. Any accidental or unintentional release of the press button during

operation of the lifting pin must be ruled out by the operator / user.

A failure to observe the following safety instructions can have

serious consequences:

Danger to persons due to mechanical or chemical influences or failure of

important lifting accessory functions!

–

Please read the safety and danger information in this section thoroughly

before putting the lifting pin into operation.

–

In addition to the instructions in these original operating instructions,

observe the generally applicable safety and accident prevention

regulations.

–

In addition to the instructions in these original operating instructions,

observe the existing national occupational, operating and safety

regulations. Also comply with existing internal factory regulations.

Table of Contents