Power Requirements; Software Updates; Product Disposal Instructions - Mitel 50005070 User Manual

CAUTION
Endpoint Damage Hazard. To avoid damaging the endpoint, make sure the endpoint is connected to the proper
power supply before powering on. Contact your system administrator for more information.
The endpoint requires any one of the following power supplies:
•
Mitel 48-volt DC Ethernet power adaptor 100-240 volt AC 50-60Hz (ES) -part number 50005301
•
An industry-standard IEEE 802.3af Power over Ethernet (PoE) power supply unit
If your endpoint uses a centralized PoE power supply unit, do not use the 48-volt DC Ethernet power adaptor. If
necessary, contact your system administrator for assistance before connecting your endpoint to the centralized power
source.
Make sure the endpoint is plugged into an uninterruptible power supply (UPS). If your endpoint is plugged into the
UPS and the power fails, it should remain powered on for about 10 minutes. If the endpoint is not plugged into a UPS
and the power fails, the current call is dropped and you will not be able to use the endpoint until the power is restored.
CAUTION
Endpoint Damage Hazard. Do not use your endpoint or disconnect it from the power supply while it is updating
software.
The endpoint may require occasional software updates when new versions are available. The endpoint is configured
to download the updates automatically. Contact your system administrator for more information.
This symbol indicates that the product is classified as electrical or electronic equipment and should not be disposed of with
other commercial or household waste at the end of its working life. For appropriate disposal and recycling instructions,
contact your local Mitel provider.
The Waste of Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) was established by the European Union to
minimize negative impact on the environment, control hazardous substances, and curtail landfill expansion by using the best
available recovery and recycling techniques.
Mitel ® Model 5330/5340 User Guide – Issue 2, October 2008

Power Requirements

Software Updates

Product Disposal Instructions

Page iii