Handling And Transportation; Checking The Floor Where The Appliance Will Be Placed - Palazzetti ECOFIRE VIVIENNE User Manual

5 HANDLING AND
TRANSPORTATION
The appliance is delivered complete with all the
parts required.
Pay attention to the tendency for the appliance to
become unbalanced.
The centre of gravity of the appliance is carried
towards the front.
Bear in mind the above also when moving the
appliance on the transport stand. It is advisable to
unpack the appliance only when it has arrived at
the installation site.
The product must be handled and un-
packed using suitable means.
Make sure that children do not play with the pack-
aging components (e.g. films and polystyrene):
Danger of suffocation!
During moving, lifting, and unpacking of the ap-
pliance the following is absolutely necessary:
• always keep it upright;
• never tip it over into a horizontal position;
• never tilt it on the front to avoid breaking the
glass of the fire box door.
• Removal of the transport pallet
Disposal can be entrusted to a third party, pro-
vided only companies authorised for the recovery
and elimination of the materials in question are
used.
Always follow the regulations in force in the
country in which the appliance is being used for
disposal of materials and possibly for the disposal
report.
To remove the appliance from the transport pallet:
• Unscrew the side fixing screws
• Lift the appliance
• Remove the transport pallet
004778982 - 09/08/2022
ITALIANO ENGLISH
5.1 Transportation
Make sure that the lifting carriage has a
payload higher than the weight of the
appliance to be lifted. The full responsi-
bility of the lifting of loads lies with the
person handling the lifting equipment.
Ensure wood or timber floors are prop-
erly protected in order to prevent the
weight of the appliance from damaging
them during movement.
During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
5.2 Checking the floor where the appliance
will be placed
Check the load capacity of the floor slab.
If a floor is not suitable for supporting the weight
of the appliance, install appropriate steel plates
(A - Fig. 14) or concrete base (A - Fig. 15) equipped
with 10x10x6 electro-welded mesh (B - Fig. 15) to
distribute the weight.
FRANÇAIS
Fig. 13
73