Fagor IO-CBI-1373 Instruction Manual page 54

OPERATION
Pre-set programmes with quick pre-heat
Some pre-set programmes require the oven to
be pre-heated. They are marked accordingly
in the above table. When you select a pre-set
programme with pre-heating and touch
confirm, the quick pre-heat
be displayed. When the set temperature is
reached, you will hear beeping, which will turn
off when you open the oven door. Place the
food in the oven and close the door, at which
point the actual pre-set programme will start.
Note: It is inadvisable to modify a pre-set
programme during the quick pre-heat phase
as this will cancel pre-set programme and the
appliance will operate with the currently set
function, duration and temperature.
End a pre-set programme.
When a pre-set programme ends, you will
hear beeping.
54
Steam programmes
When the appliance is on, touch
cess the pre-set programmes menu – the
pre-set programme "P01" will be shown on
to
the display. Use the
pictogram will
select the programme marked as P01S-P09S.
The oven is equipped with special stainless
steel bowls:
- perforated for vegetables and fish
- solid for meat.
Place the steel bowls with food on the wire
shelf. Close the oven door.
Water container drawer is located in the
front panel. Push and then pull the container
drawer. Pour 0.5 l of water into the container.
(Add water if the
When there is enough water in the container
you will hear a beep. Close the container
drawer.
Select the P01S-P09S programme and touch
OK to confirm and start the programme.
IMPORTANT: When you hear a beep during
a programme and the
to add more water. Proceed the same as you
added water for the first time. The steam indi-
cator will stop flashing when you have added
enough water.
NOTE: When water runs out the programme
is not interrupted!
When the set time has elapsed, you will
hear beeping. Touch any sensor to mute the
to ac-
and sensors to
steam indicator is flashing)
is flashing, you need