Fagor IO-CBI-1373 Instruction Manual page 52

OPERATION
but you can set the oven to turn off using timed
operation function of delayed timed operation
function. The only exception is the pyrolytic
cleaning function, which cannot be modified.
Timed operation
In this mode the oven will turn off after a set
duration. You can set the duration from 1 min-
ute to 10 hours. To set timed operation for any
oven function, touch and hold the
and the timer symbol flashes in the display.
Touch the sensor again, the display will
show the symbol. Now you can:
Use to set the duration and touch
confirm.
Use and
Touch to confirm the adjusted setting.
To cancel timed operation use
duration down to
confirm.
Timed operation will interrupt the active oven
function. When the set Duration has elapsed,
you will hear beeping. Touch any sensor
except to mute the beeping. When the
beeping is muted the appliance enters the
operation mode.
Note: When you use the
beeping, the appliance will allow you to adjust
the Duration time.
Delayed timed operation
You can set the oven to start at a specific time
and operate for a set Duration. You can delay
the oven start from 1 minute to 10 hours, and
set the Duration for up to 10 hours. To activate
the delayed timed operation, first set the timed
operation. Then touch and hold the
again and the timer
the display. Touch the
the pictogram will flash on the display.
52
sensor,
to adjust the time settings.
to adjust
and touch
sensor to mute the
symbol will flash on
sensor twice, and
Now you can:
Use to set the time for the oven to turn off
and then touch
Correct the oven on time with the sensors
and
setting.
To cancel timed operation use
duration down to the lowest possible value
and touch
Timed operation will interrupt the active oven
function. When the set time has elapsed, you
will hear beeping. Touch any sensor to mute
the beeping. When the beeping is muted the
appliance enters the operation mode.
to
Pre-set programmes
These are programmes with specific settings
of function, temperature and duration that are
to most suitable for a given dish. When the ap-
pliance is on, touch
programmes menu – the pre-set programme
"P01" will be shown on the display. Use the
and
gramme from the table below. Then touch
to confirm your selection and the appliance
will start to operate.
sensor
to confirm.
. Touch to confirm the adjusted
to confirm.
to access the pre-set
sensors to select the pre-set pro-
to adjust