Cleaning & Disinfection - OAKWORKS Spine Positioning System II User Manual

Imaging and pain management accessory
Hide thumbs Also See for Spine Positioning System II:
Table of Contents

Advertisement

CLEANING & DISINFECTION
R E C O M M E N D E D C L E A N E R S/D I S I N F E C T A N T S
Reference the Recommended Cleaners and Disinfectant list (MMINML0008-EN) that came with the
table. This information can also be found at www.oakworksmed.com under product information.
All cleaners and disinfectants have the ability to degrade the upholstery to some extent. However, fol-
lowing the recommended cleaner and disinfectant list and cleaning process will provided the best care
for your product and support a long product life.
OAKWORKS® recommends a prepackaged wipe for cleaners/disinfectants to ensure best distribution
of disinfectant for the required kill time, without leaving excess residue and/or overexposing compo-
nents therefore minimizing the potential for damage to materials. Please read and follow disinfectants
manufacturers' directions for cleaning and disinfection.
OAKWORKS® does NOT recommend the use of cleaners/disinfectants containing Hydrogen Peroxide,
Acetic Acid, or Phenolics. These chemicals can cause damage to the appearance and/or material
integrity of various components. Also, while the recommended cleaners/disinfectants list includes
products containing Quaternary Ammonium compounds ("quats"), not all products containing quats
are approved for use. Some contain additional detergents and/or surfactants which can damage some
materials.
A note on Bleach: While a 10% sodium hypochlorite (household bleach) solution (EPA No.: 5813-100
or equivalent) can be an effective disinfectant and is dilute enough to be benign to most materials, it
alone is not an effective cleaner and a separate product must be used for the initial cleaning steps of
the procedure. Because of possible chemical incompatibilities between various cleaning products and
bleach, utmost care must be taken by the user to avoid potential exposure to harmful or toxic by-prod-
ucts of the combination. Also, because bleach leaves a potentially corrosive residue as it evaporates,
it must be rinsed with clean water after disinfection.
Use of non-approved cleaners or disinfectants may lead to damage to upholstery and other
materials found on the table and will void the warranty.
C L E A N I N G P R O C E S S
Follow the cleaners/disinfectant manufacturers' directions for use. Please note that cleaning and dis-
infecting an OAKWORKS ® product is a two part process. First it must be cleaned of any visible soil,
then it can be disinfected. Please follow this procedure for best results:
1. Using an approved cleaner or mild liquid soap and water, clean any visible soil off of the prod-
uct, working from the top to the bottom of the product. It is recommended that the upholstery be
cleaned at least once a week to prevent disinfectant build up.
2. Rinse with clean water and dry with a clean cloth or towel.
3. Using an approved disinfectant, thoroughly disinfectant all surfaces of the product and any high-
contact areas, making sure they remain wet for the disinfectant manufacturer's recommended
contact time. Do not allow disinfectant to pool on the upholstery after the recommended contact
time.
4. Wipe off any excess liquid with a cloth or towel and clean water.
5. Dry all surfaces with a clean cloth or towel.
Avoid using writing instruments or other similar instruments around the upholstery as it can cause per-
manent staining. If this does occur, do not wipe with an alcohol based cleaner. Instead, blot the stain
with a clean cloth/ paper towel. Use a 10% bleach dilution to remove the stain. Follow this with a rinse
of clean water.
15

Advertisement

Table of Contents
loading

Table of Contents