Airflow Redirection Hood; Airflow Redirection Hood Installation - CardioQuip MCH-1000 Operators & Service Manual

Airflow Redirection Hood
Airflow Redirection Hood
MCH-10ARH
Airflow Redirection Hood Installation
PH2
PH2
The Airflow Redirection Hood (MCH-10ARH) redirects
Refrigeration Module's exhaust downward. This device is a possible risk
mitigation component which redirects potential aerosols downwards
and away from the surgical field.
1. With the Refrigeration Module unplugged and powered off, use a
#2 Phillips screwdriver to remove the four (4) side panel screws
from the Refrigeration Module cover (two per side).
2. Slide the Airflow Redirection Hood down into place on top of the
Refrigeration Module. Note the correct orientation of the screw
holes in the Airflow Redirection Hood - it only fits properly one way.
When the holes are aligned properly, the Airflow Redirection Hood
will be centered on the exhaust grille.
3. Replace the four side panel screws, ensuring that they thread
straight in. The screwdriver will be at a slight angle, so care must be
taken to ensure that the screws do not cross-thread. Tighten the
screws securely.
OPTIONAL COOLING MODULES | Refrigeration Module
the
37