Suzuki DF 2.5 Service Manual page 45

3-8 IGNITION AND ELECTRICAL
5. Remove the flywheel from the crankshaft using the proper
marketing tool.
6. Remove the key from the crankshaft.
INSTALLATION
Installation is reverse order of removal with the special attention
to the following steps.
Flywheel magneto
• Clean the flywheel and crankshaft mating surfaces with clean-
ing solvent.
• Tighten the flywheel nut to the specified torque.
 09930-40113: Flywheel holder
09930-40120: Rotor holder attachment
 Flywheel nut: 45 N·m (4.5 kg-m, 32.5 lb-ft)
Igniter unit
• Install the igniter unit with an air gap of 0.5 mm between the
both core ends and the flywheel. Check the gaps at the
machining part of the flywheel as shown in the figure.
 09900-20803: Thickness gauge
Air gap: 0.5 mm (0.02 in)
• Tighten the two igniter unit bolts to the specified torque.
 Igniter unit bolt: 10 N·m (1.0 kg-m, 7.0 lb-ft)