Icom IC-7100 Service Manual Addendum page 235

4-4 ID ADJUSTMENTS (continued)
1) Set or modify the adjustment value as specifi ed by rotating [MAIN DIAL].
2) Push [SET] to store the value.
ADJUSTMENT ITEM
ID ADJUSTMENT 1 • Display: "ID SET HF"
2 • Display: "HFID1V"
3 • Display: "HFID2V"
4 • Display: "DID SET"
5 • Display: "DIDV"
6 • Display: "ID SET V/UHF"
7 • Display: "VUIDV"
ID-APC OPERATING 1 • Display: "ID-APC HF"
POINT ADJUSTMENT
Push [MIC/RF PWR] to return to the main adjustment menu.
VD ADJUSTMENT Push [NR] to enter the REF adjustment menu.
VD-APC ADJUSTMENT 1
2 • Display: "VD-APC"
3 • Display: "VD-APC START 11.8V"
4 • Display: "VD-APC 75% 11.0V"
The REF adjustment menu is displayed.
Push [MIC/RF PWR] to return to the main adjustment menu.
TRANSCEIVER'S CONDITION
• Transmit continues
–
OPERATION
• Connect the 50 Ω dummy load to
[ANT1].
• Push [SET]. (Automatically starts
to transmit.)
–
• Connect the 50 Ω dummy load to
[ANT1].
4-4
ADJUST
VALUE
POINT
– Push [SET].
Push [SET] again.
(A beep sounds, and
then beeps sound 3
sec. later. Then next
adjustment item is
selected.)
Push [SET].
(A beep sounds,
transmission stops,
and then beeps sound
3 sec. later. Then next
adjustment item is
selected.)
Push [SET].
(Then the next
adjustment item
is selected, and
automatically starts to
transmit.)
Push [SET].
(A beep sounds,
transmission stops,
and then beeps sound
3 sec. later. Then next
adjustment item is
selected.)
Push [SET].
(Then the next
adjustment item
is selected, and
automatically starts to
transmit.)
Push [SET].
(A beep sounds,
transmission stops,
and then beeps sound
3 sec. later.
–
– Push [NB].
Push [SET].
11.9 V
[MAIN DIAL] Push [SET].
11.1 V
Push [SET].