Table of Contents
Advertisement
12. Remove
⁄
"-20 x
1
1
4
⁄
" flat washer from end of cutterhead guard
5
8
shaft, loosen set screw in rabbeting table,
then slide shaft down through cutterhead
guard mounting hole (see Figure 17).
— If guard does fully seat in hole, proceed to
Step 13.
— If guard does not fully seat in hole, rotate
guard until it is fully seated, then proceed
to Step 13.
Figure 17. Installing cutterhead guard.
13. Align corner of cutterhead guard with edge
of carriage, then secure set screw,
⁄
" Phillips head screw, and
1
2
removed in Step 12 (see Figure 18).
Carriage
Figure 18. Cutterhead guard aligned with
carriage.
Model G0526A40 (Mfd. Since 12/22)
⁄
" Phillips head screw and
2
Cutterhead Guard
Assembly
Cutterhead Guard
Mounting Hole
Infeed Table
⁄
"-20 x
1
4
⁄
" flat washer
5
8
Alignment Area
Cutterhead
Guard
14. Rotate cutterhead guard counterclockwise
and secure temporarily with a piece of scrap
wood (see Figure 19).
Scrap
Wood
Figure 19. Cutterhead guard secured in place.
15. Place carriage support key and fence onto
fence carriage base, making sure fence fits
over key (see Figure 20), then insert fence
lock handle and secure with
and locking jam nut.
Top View
Carriage
Support
Key
Bottom View
Flat Washer
& Locking
Jam Nut
Figure 20. Fence assembly installed onto
carriage base and secured.
⁄
" flat washer
1
2
Fence
Lock
Handle
Fence
Carriage
Base
-19-
Advertisement
Table of Contents
