Transition Networks E-TBT-FRL-1200 User Manual

Transition Networks E-TBT-FRL-1200 User Manual

10base-t/10base-fl multi-port media converter

Advertisement

Quick Links

COMPLIANCE INFORMATION

UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user's own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen
werantwortlich ist.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées
VCCI Class 1 Compliance
This equipment is in the 1st Class category (information equipment to be used in commercial and/or
industrial areas) and conforms to the standards set by the Voluntary Control Council For Interference by
Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in
commercial and/or industrial areas. When used in a residential area or in an adjacent area thereto,
interference may be caused to radio and TV receivers, etc. Read the instructions for correct handling.
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 2000 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A.
E-TBT-FRL-1200, E-TEL-FRL-1200, E-TBT-FRL-0600
The rack-mountable E-TBT-FRL-1200, E-TEL-FRL-1200, and
E-TBT-FRL-0600 series multi-port media converters with
the network administrator of a large and complex network to extend the
distances between multiple sets of 10BASE-T and 10BASE-FL devices.
TP LINK
1
SWITCH
FBR LINK
1
2
POWER
ACT
ACT
E-TBT-FRL-1200
connections between Ethernet
connectors) and Ethernet
connectors of one type – selected, according to network requirements).
E-TEL-FRL-1200
converter connections between Ethernet
Telco connector) and Ethernet
fiber connectors of one type – selected, according to network requirements).
E-TBT-FRL-0600
connections between Ethernet
and Ethernet
one type – selected, according to network requirements).
Fiber Cable/Connector Options* by Model:
E-TBT-FRL-xx00/E-TEL-FRL-1200: multimode fiber, ST connectors
E-TBT-FRL-xx00(SC)/E-TEL-FRL-1200(SC): multimode fiber, SC connectors
E-TBT-FRL-xx00(MT)/E-TEL-FRL-1200(MT): multimode fiber, MT-RJ connectors
E-TBT-FRL-xx00(SM)/E-TEL-FRL-1200(SM): singlemode fiber, SC connectors
E-TBT-FRL-xx00(L)/E-TEL-FRL-1200(L): singlemode fiber, SC connectors
*See page 9 for detailed specifications.
*The LinkAlert
disabled using switches on the front of
the multi-port media converter, allows
each media converter port to pass link
faults between connected 10BASE-T
and 10BASE-FL devices.
33140.B
10BASE-T/10BASE-FL
Multi-Port Media Converter
USER'S GUIDE
TP LINK
2
TP LINK
3
TP LINK
4
TP LINK
5
TP LINK
6
TP LINK
7
FBR LINK
FBR LINK
FBR LINK
FBR LINK
FBR LINK
SWITCH
FBR LINK
3
4
ACT
ACT
ACT
ACT
ACT
Provides twelve (12) independent media converter
(shown)
over twisted-pair copper (twelve RJ-45
over singlemode OR multimode fiber (twelve fiber
Provides twelve (12) independent media
(not shown)
over twisted-pair copper (one 50-pin
over singlemode OR multimode fiber (twelve
Provides six (6) independent media converter
(not shown)
over twisted-pair copper (six RJ-45 connectors)
over singlemode OR multimode fiber (six fiber connectors of
E-TBT-FRL-xx00 in the Network . . . .2
feature, enabled and
Installation . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . .6
Fault Isolation and Correction . . . . .8
Cable Specifications . . . . . . . . . . . . .9
Technical Specifications . . . . . . . . .11
Compliance Information . . . . . . . . .12
Minneapolis, MN 55344 USA
allow
LinkAlert™*
TP LINK
TP LINK
9
TP LINK
10
TP LINK
TP LINK
8
11
12
FBR LINK
FBR LINK
FBR LINK
FBR LINK
FBR LINK
ACT
ACT
ACT
ACT
ACT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-TBT-FRL-1200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Transition Networks E-TBT-FRL-1200

  • Page 1: Compliance Information

    Multi-Port Media Converter E-TBT-FRL-1200, E-TEL-FRL-1200, E-TBT-FRL-0600 USER’S GUIDE The rack-mountable E-TBT-FRL-1200, E-TEL-FRL-1200, and E-TBT-FRL-0600 series multi-port media converters with the network administrator of a large and complex network to extend the distances between multiple sets of 10BASE-T and 10BASE-FL devices.
  • Page 2: Technical Specifications

    E-TEL-FRL-1200(SM), E-TEL-FRL-1200(L), E-TEL-FRL-1200(MT) Regulation: EMC Directive 89/336/EEC Purpose: To declare that the E-TBT-FRL-0600, E-TBT-FRL-1200 or E-TEL-FRL- 1200 to which this declaration refers is in conformity with the following standards. EMC-CISPR 22: 1985 Class A; EN 55022: 1988 Class A; EN 50082-1:1992;...
  • Page 3: Cable Specifications

    CABLE SPECIFICATIONS (continued) COPPER CABLE Each RJ-45 connector requires 2 pairs of Category 5 rated cable. The 50-pin Telco connector requires 24 pairs of Category 5 rated cable. Either shielded twisted-pair (STP) or unshielded twisted-pair (UTP) can be used. DO NOT USE FLAT OR SILVER SATIN WIRE. CATEGORY 5: Gauge 24 to 22 AWG...
  • Page 4: Installation

    INSTALLATION Install E-TBT-FRL-xx00 at Site WARNING: During the site installation, handle the E-TBT-FRL-xx00 in such a way that the E-TBT-FRL-xx00 does not fall. Failure to observe this warning could result in injury to personnel and/or equipment damage. To install the E-TBT-FRL-xx00 in 19-inch rack cabinet: NOTE: Brackets and screws are provided.
  • Page 5: Fault Isolation And Correction

    FAULT ISOLATION and CORRECTION If the multi-port media converter fails, isolate and correct the fault by determining the answers to the following questions and then taking the indicated action: Is the POWER LED on the multi-port media converter illuminated? • Is the power cord properly installed in the media converter and in the grounded AC outlet? •...
  • Page 6: Operation

    INSTALLATION (continued) Install Cable (continued) FIBER Locate or build 10BASE-FL compliant fiber cable with male two- stranded TX to RX connectors at both ends. Connect male TX and RX cable connectors at one end of cable to TX and RX female connectors, respectively, on media converter port.

This manual is also suitable for:

E-tel-frl-1200E-tbt-frl-0600E-tbt-frl-0600(sc)E-tbt-frl-0600(sm)E-tbt-frl-0600(l)E-tbt-frl-0600(mt) ... Show all

Table of Contents