Mitsubishi Electric CITY MULTI PUMY-P112VKM6 Service Manual page 133

Settings menu
Function setting
Lossnay
Service menu:
Cursor
F1 F2
2. Set the function.
• Press the F1 or F2 button to move the cursor to one of the following: M-NET address, function setting number, or
• Press the F3 or F4 button to change the settings to the desired settings.
• Once the settings have been completed, press the [
A screen will appear indicating that the settings information is being sent.
• To check the current settings of a given unit, enter the setting for its M-NET address and function setting number,
select Conf for the Function, and press the [
A screen will appear indicating that the settings are being searched for.
When the search is done, the current settings will appear.
When the settings information has been sent, a screen will appear indicating its completion.
• To make additional settings, press the [
numbers for other indoor units by following the same steps.
Notes:
• Refer to the indoor unit Installation Manual for information about the factory settings of indoor units, function setting
numbers, and setting values.
• Be sure to write down the settings for all functions if any of the initial settings has been changed after the completion
of installation work.
Function setting
M-NET address
Function No.
Data
Function
Select:
Cursor
13-5-2. PAR-SL97A-E
Functions can be selected with the wireless remote controller. Function selection using wireless remote controller is avail-
able only for refrigerant system with wireless function. Refrigerant address cannot be specified by the wireless remote
controller.
Operating instructions
CHECK
1. Press the
• Press the TEMP
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
2. Enter the unit number.
• Press the TEMP
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
By setting the unit number with the
Detect which unit is assigned to which number using this function. If unit number is set to AL, all the indoor units in
the same refrigerant system start performing fan operation simultaneously.
Notes:
• If a unit number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the unit number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the unit number.
3. Select a mode.
• Press the TEMP
• Direct the wireless remote controller toward the sensor of the indoor unit and press the
→ The sensor-operation indicator will blink and beeps will be emitted to indicate the current setting number.
Setting number: 1 = 1 beep (1 second)
Notes:
• If a mode number that cannot be recognized by the unit is entered, 3 beeps of 0.4 seconds will be emitted.
Reenter the mode number.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the mode number.
4. Select the setting number.
OCH790 _133
F3 F4
3
32
2
Set /Conf
Address
button twice continuously. →
button once to set the address number to ˝50˝.
button to enter the unit number.
min
button to set a mode.
2 = 2 beeps (1 second each)
3 = 3 beeps (1 second each)
] button.
] button.
] button to return to the screen shown in the above step. Set the function
Function setting
M-NET address
3
Function No.
32
2
Data
Sending data
appears and ˝00˝ blinks.
CHECK
button, the specified indoor unit starts performing fan operation.
setting value.
Function setting
M-NET address
Function No.
Data
Setting completed
Return:
h
button.
min
button.
h
button.
3
32
2