Mitsubishi Electric CITY MULTI PUMY-P112VKM6 Service Manual page 132

: Switch the airflow direction and start the test run.
: Switch the louver and start the test run.
: Start the test run.
3. Stop the test run.
• Press the
• After 2 hours, the stop signal is transmitted.
13-4-4. PAR-U02MEDA
Operating instructions
• Read the section about Test run in the indoor unit Installation Manual before performing a test run.
• During the test run, indoor units will be forced to operate in the Thermo-ON status.
Except the set temperature, normal operation functions are accessible during test run.
• By selecting the address of another indoor unit, the liquid pipe temperature of the selected unit can be monitored.
• The test run will automatically end in 2 hours.
Notes:
• When AHC is controlled from the controller
To monitor the operating status of AHC, touch the [<] button on the [Test run] screen and access the [General equip-
ment] screen.
• To set the humidity setting for the humidifier (when one is connected to the AHC), touch the [>] button on the [Indoor
unit setting] screen.
Test run
Address Remain 2:00
00
1
-
＞
ON
Cool
Mode
[Test run screen]
13-5. Function setting
13-5-1. PAR-41MAA
Operating instructions
1. Open the function setting screen.
• Select ˝Service˝ from the main menu, and press the [
• Select ˝Setting˝ from the service menu, and press the [
• Select ˝Function setting˝ and press the [
Function setting screen will appear.
OCH790 _132
button to stop the test run.
[MON] 10:45 Test run
Fan speed
LED
＞
Pipe
+ 9.0°C
＞
＞
Louver
＞
[Indoor unit setting screen]
Air direction
＞
＞ ＞
＞
Auto Swing
LOSSNAY
＞
＞ ＞
High
On
] button.
] button.
] button.