Toshiba JKSSS Series Instruction Manual page 9

Basic Installation and Operation
Guide
Handling and Storage
• Use proper lifting techniques when moving the equipment, including properly sizing up the load, getting
assistance, and using a forklift if required.
• Store in a well-ventilated location, preferably in the original packaging, if the equipment will not be used upon
receipt.
• Store in a cool, clean, and dry location. Avoid storage locations with extreme temperatures, rapid temperature
changes, high humidity, moisture, dust, corrosive gases, or metal particles.
• The storage temperature range of the breaker is 23° to 104° F (-5° to 40° C).
• DO NOT store the unit in places that are exposed to outside weather conditions (e.g., wind, rain, snow).
• Store in an upright position as indicated on the shipping carton.
• Include any other product-specific requirement.
Disposal
Never dispose of electrical components via incineration. Contact your state environmental agency for details
on disposal of electrical components and packaging in your area.
Installation Precautions
Location and Ambient Requirements
• Adequate personnel working space and illumination must be provided for adjustment, inspection, and
maintenance of the equipment. In the U.S., refer to NEC Article 110-34 for requirements. Outside the U.S.,
follow applicable local electrical code requirements.
• Avoid installation in areas where vibration, heat, humidity, dust, fibers, steel particles, explosive/corrosive mists
or gasses, or sources of electrical noise are present.
• Do not install the starter where it may be exposed to flammable chemicals or gasses, water, solvents, or other
fluids.
• The ambient operating temperature shall be between 0° to 40° C (32° and 105° F).
• Allow proper clearance spaces for installation. Do not obstruct the ventilation openings. Refer to the
recommended minimum installation dimensions as shown on the enclosure outline drawings.
Mounting Requirements
• Only Qualified Personnel should install this equipment.
• Install the unit in a secure upright position in a well-ventilated area.
• A noncombustible insulating floor or mat should be provided in the area immediately surrounding the electrical
system at the place where maintenance operations are to be performed.
TOSHIBA
JKSSS Series Solid State Soft Starters