Table of Contents
Advertisement
An optional sealed rechargeable NiMH battery is also available with an AC powered
cradle charger. Turn the X4 detector off. Remove the original (alkaline) battery holder
from the detector. Insert the sealed rechargeable NiMH battery pack, turn the locking
tab 90° clockwise and return the locking tab to its original position.
To charge the X4 in the cradle charger, first turn the X4 detector off. Ensure the
cradle charger POWER light is illuminated (orange LED).
Gently push the X4 gas detector (including the supplied rubber boot) into the open
bay of the recharger cradle. The front of the X4 should be visible from the front of
the cradle charger Once correctly inserted the cradle charger CHARGING light will
illuminate (RED for charging mode). Leave the X4 unit in the cradle charger until the
CHARGING light changes color to GREEN. Pull the X4 vertically out of the cradle
charger. The X4 detector is now charged and can be switched on.
Warning
use only the approved Honeywell analytics charger (part number 2566-
0484) when charging the sealed rechargeable battery pack (part number
2566-0482 for Minimax4 series and part number 2566-0462 for impulse X4
series). use of any other charger will void the intrinsic safety certification of
the instrument. use only the Honeywell analytics supplied aC adaptor (part
number 2566-0483) to connect to the charger (part number 2566-0484).
the battery charger units contain no user serviceable parts; no attempt
should be made to alter or repair the cradle charger.
note
Periodically inspect the battery holder terminal contacts for build up of
dirt. Remove any debris using soft cloth and industrial alcohol.
6-2. Installing or Removing the Memory Card
Warning
do not install or remove the memory card in the detector or attempt to read,
download or write to the memory card using a memory card reader and/or
computer in potentially hazardous atmospheres.
use only approved memory cards, part # 2566-0435, which are available
from Honeywell analytics. use of any other manufacturer or type will
violate intrinsic safety requirements.
•
Turn the detector off.
•
Remove the battery holder from the detector. (See Section 6-1 Replacing
the Batteries.)
•
To remove the memory card from the detector, press on its edge until a 'click'
sound is heard, which indicates the memory card has been released. The
memory card can now be pulled out from the detector.
•
To install the memory card, insert it into the card slot and press on its edge
until a 'click' sound is heard, which indicates that it is secured in the card slot.
Pay attention to the memory card direction (see diagram below).
•
Insert the battery holder into the detector. (See Section 6-1 Replacing the
Batteries.)
X4 Series
Advertisement
Table of Contents
