note
If the user fails to input the correct pass code 3 times consecutively, the
detector will return to measuring mode
5-2. Changing the Detector Set-Up
The set-up mode menu structure is shown in Appendix A (A-, A-4, A-5, and A-
6).
In set-up mode, pressing the UP or DOWN buttons scrolls to a function and pressing
the ON/OFF button selects the function, so that the displayed value or status may
be changed.
For each value/status, pressing the UP button increases the displayed value or
scrolls through the status, pressing the DOWN button decreases the displayed value
or scrolls through the status. Pressing the ON/OFF button accepts the displayed
value or status.
note
The previous value or status can be restored by pressing the UP and DOWN
buttons together instead of pressing the ON/OFF button.
Once the displayed value or status has been changed and accepted, the new value
or status is stored within the detector.
5-3. Exiting the Set-Up Mode
In set-up mode, if no button is pressed within 0 seconds, or both the UP and DOWN
buttons are pressed together and held for seconds, the detector will revert back to the
measuring mode.
X4 Series
1