Table of Contents
Advertisement
G For #5005 or later
(1) Remove the scanning optics unit.
"I Removal procedure"
(2) Write down on the notepad the reading width adjustment value indicated on the label
located on the side of the new scanning optics unit.
REFERENCE
Use this value for adjustment after installation (because it becomes inaccessible when
the scanner is pushed in).
X= .
(3) Install the new scanning optics unit.
"I Installation procedure"
(4) Perform adjustment after installation of the scanning optics unit.
"I Check/adjustment procedure"
009-058-03
08.30.2002 FM3476
Scanning optics unit
CR-IR347 Service Manual
MC - 265.5
FR7H3742.EPS
MC - 265.5
Advertisement
Table of Contents
