Instruction For 24K - 48K Models Only - Bosch Climate 5000 Series Installation Instructions Manual

Step 4: Connect 2 wires of decorative panel to main board of the unit
5-core wire
Figure 50
Step 5: Fasten the Control Box Lid with 2 Screws
Figure 51
Step 6: Close the Intake Grille and Close the 2 Grille Hooks
Figure 52
If the height of the indoor unit needs to be adjusted, you can do so
through the openings at the panel's four corners. Make sure that the
internal wiring and drainpipe are not affected by this adjustment.
Bosch Climate 5000 Series Four Way Cassette Ductless Split Air Conditioner / Heat Pump (06.2022)

11.2 Instruction for 24k - 48k Models Only

Step 1: Remove Front Grille
10-core wire
Figure 53
Step 2: Remove the installation covers at the four corners by sliding them
outwards
Figure 54
Step 3: Install the panel

 Push both of the tabs towards the middle simultaneously to unlock
the hook on the grille.
 Hold the grille at a 45° angle, lift it up slightly and detach it from the
main body.
Remove the grid screws
Grille switch
Grille screw cover
Align the front panel to the main body, taking into account the position of
the piping and drain sides. Hang the four latches of the decorative panel to
the hooks of the indoor unit. Tighten the panel hook screws evenly at the
four corners.
Tighten the screws until the thickness of the sponge between the main
body and the panel reduces to 4-6mm (0.2-0.3"). The edge of the panel
should be in contact with the ceiling well.
Installation Instructions
45°
| 29