Test Run; Before Test Run; Test Run Instructions - Bosch Climate 5000 Series Installation Instructions Manual

Installation Instructions

13 Test Run

13.1 Before Test Run

Only perform test run after you have completed the following steps:

Electrical Safety Checks:
Verify your line voltage is correct based on the specifi cation.

Gas Leak Checks:
Check all flare nut connections and confirm that the system is not leaking

Confirm that gas and liquid (high and low pressure) valves are fully open

13.2 Test Run Instructions

You should perform the Test Run for at least 30 minutes.
1. Energize power at the outdoor unit.
2. Press the ON/OFF button on the remote controller to turn it on.
3. Press the MODE button to scroll through the following functions, one at a
time:
—
COOL – Select lowest possible temperature
—
HEAT – Select highest possible temperature
4. Let each function run for 5 minutes, and perform the following checks:
List of Checks to Perform
No electrical leakage
Unit is properly grounded
All electrical terminals properly covered
Indoor and outdoor units are solidly installed
All pipe connection points do not leak
Water drains properly from drain hose
All piping is properly insulated
Unit performs COOL function properly
Unit performs HEAT function properly
Indoor unit louvers rotate properly
Indoor unit responds to remote controller
Table 13
5. After the Test Run is successfully complete, and you confi rm that all check
points in List of Checks to Perform have PASSED, do the following:
a. Using remote control, return unit to normal operating temperature.
b. Using insulation tape, wrap the indoor refrigerant pipe connections that
you left uncovered during the indoor unit installation process.
3 4 |
Pass Fail
Bosch Climate 5000 Series Four Way Cassette Ductless Split Air Conditioner / Heat Pump (06.2022)
A protection feature prevents the air conditioner from being activated for
approximately 3 minutes when it is restarted immediately after shut off .