Settings Mode - Kettler HOI SPEED Instructions Manual

|
played in the HR window and the console shall connect to the HR strap. Once the connec-
tion to the ANT+ HR strap has been made, the detected heart rate value shall be displayed in
the HR window and the heart icon shall blink at the same rate as the detected heart rate.
If a connection has been made to an ANT+ HR strap the console shall also be able to connect
a smartphone app simultaneously via BLE. The behavior described above applies. Note that
the user must connect to a heart rate strap prior to establishing a connection to a smart-
phone if they want to connect to both simultaneously.
CONNECTION RESET
If you are having an issue connecting with any device, you can try to reset the console. Re-
setting the console also resets the state of the connections to peripheral devices.
A console reset can be performed in IDLE MODE. When in IDLE MODE, hold the MINUS
button down for 5 seconds. The console will then shutdown. To wake the console back up,
begin pedaling. If you are pedaling during the reset, the console will blank out and then turn
back on but the connection states will have been cleared. Note that it may be necessary to
close and reopen any smartphone or tablet app that you would like to connect to in order to
ensure that the app's connection state has also been reset.

SETTINGS MODE

SETTINGS SCREEN
To enter CONFIGURATION MODE the press START, PLUS, and MINUS simultaneously.
The graphic below shows the SETTINGS screens:
- Button Pressed
+ Button Pressed
+ Button
Pressed
There are six options provided on these screens and they are as follows:
• STAT – Review the total accumulated time, total accumulated distance, and firmware
version
• HR – Test the HR system
• BEEP – Adjust the volume of the beeper
• UNIT – Switch between Metric and Imperial units
• ENER – Switch between displaying KCAL and KJ
• INFO – Set the weight value used for calculating calories
The first screen that will be shown is the one for STAT. To select between the available
Settings, the user shall press either the MINUS or PLUS button to navigate to the next or
previous choice respectively.
If the user presses the START/ENTER button they are selecting the displayed Setting and
the system shall transition to the applicable Setting screen.
To exit the SETTINGS screens and return to the IDLE screen the user shall press the
WORKOUTS button.
46 ENGLISH
- Button Pressed - Button Pressed
+ Button Pressed + Button Pressed
- Button Pressed - Button Pressed
+ Button Pressed + Button Pressed
- Button
Pressed