Table of Contents
Advertisement
4
Turn OFF the mill.
5
Disconnect all power and data connections.
6
Move the mill onto a cart that is capable of supporting the weight of the mill and its accessories. You are advised to use a
suitable cart rather than moving the mill by hand. Lifting and carrying should be kept to a minimum.
The mill weighs approximately 170 lbs (70 kg). Lifting the mill requires at least two people.
Those lifting the mill should:
• Stand close to the mill with their feet approximately shoulder width apart, and one foot slightly in front of the other for
optimal balance.
• Squat down by bending at the knees, not at the waist, keeping their backs as vertical as possible.
• Firmly grasp the mill before beginning the lift.
Be certain to lift the mill by the underside metal bottom plate located on each side of the mill, not by the plastic covers..
• Refrain from twisting their bodies and slowly begin lifting, using their legs, not their back, to lift.
• Keep the mill as close to the body as possible to minimize stress on the back.
• If turning is required, turn by shuffling their feet, not by twisting their body.
• If it is necessary to place the mill below the level of their waists, each person lifting should follow these procedures in
reverse order, keeping their backs vertical and bending at the knees.
• Be careful to avoid obstacles.
System Information and Upgrades
Software and Hardware
System software and hardware upgrades are initiated through Planmeca only. No software or hardware should be added or
deleted to/from the Planmeca systems without prior approval of Planmeca. Doing so may result in damage to the system and will
void the product warranty.
Mill Software Version
The version number is displayed on the home screen.
When placing a call for service or support, you may be asked to provide the serial number, model number, software version
number, or similar identifying data. The serial number and model number are located on the Product Identification Label, affixed
to the rear of each unit. "Labels" on page 28.
Planmeca PlanMill 40 S User Manual
PlanMill 40 S Introduction
5
Advertisement
Table of Contents
