Send To Mill; Mill Tab Settings; Mill Network Settings; Material/Shade Settings - Planmeca PlanMill 40 S User Manual

Send to Mill

1 Click Send to Mill when you are satisfied with the restoration and mill set up.
2 If you have multiple mills, select the desired mill from the list. See "Mill Network
Settings" below for how to create/edit this list. Use the Favorite button to designate the
highlighted mill as the default. The favorite mill is always at the top of the list.
3
Confirm the desired setting.
• Standard is recommended for full coverage restorations.
• Detailed is recommended for partial coverage restorations.
Detailed mode is not recommended for e.max c14 blocks and may result in broken tools.
Crown
I-12 Detailed
C-14 Standard
C-16 Standard
IPS e.max ZirCAD Detailed

Mill Tab Settings

Click Settings to change any of the settings listed below.

Mill Network Settings

If you have multiple mills on your network, you can set them up here.
• To add a new mill to the network, click the Plus sign in the top right then type the Mill
Name and IP Address.
• To edit one of the mills, click the name in the list and edit the details on the left.
• To remove a mill, click the name in the list and then click the Minus sign in the top right.

Material/Shade Settings

The material and shade for the current restoration can be changed here.

Margin Thickness Settings

[PlanCAD systems only]
Planmeca PlanMill 40 S User Manual
Bridges Inlay
Standard
Detailed
Onlay Veneer
Detailed
N/A
Importing for Milling 25