Clean Cab Floor - Hitachi ZAXIS 130-6N Operator's Manual

Adjust Compressor Belt Tension
1. Loosen lock nut (2) of tension pulley (1).
2. Move tension pulley (1) by adjusting bolt (3) under
tension pulley (1) until tension is correct.
3. Securely tighten bolt (2) of tension pulley (1).
4. After that tighten bolt (3).
IMPORTANT: When a new belt is installed, be sure to re-
adjust the tension after operating the engine for 3 to 5
minutes at slow idle speed to be sure that the new belt
is seated correctly.

Clean Cab Floor

--- as required
IMPORTANT: When cleaning the cab floor with tap
water, spray the floor only. Take care not to splash
the surrounding area. Do not increase water spray
speed by restricting the hose end, and do not use high
pressure steam for cleaning. Be sure to completely
remove any moisture from the surrounding area.
1. Park the machine on solid and level surface. Lower the
bucket to the ground. Before cleaning, stop the engine.
2. Sweep the cab floor clean using a brush, and brush dust
from the cab floor while spraying water.
3. When cleaning the floor mat, sweep dust (water) along
the grooves on the floor mat.
4. When cleaning after removing the floor mat, sweep dust
(water) through one cleaning hole.
MAINTENANCE
7-112
1
2
3
Air Compressor Pulley
M1G6-07-013
MDAA-07-041