Adjusting Operator's Seat; Seat Height And Angle Adjustment; Console And Seat Fore-Aft Adjustment; Seat Fore-Aft Adjustment - Hitachi ZAXIS 130-6N Operator's Manual

Adjusting Operator's Seat

d
WARNING: Adjust the seat only after lowering the
front attachment to the ground and pulling up the
pilot control shut-off lever to the LOCK position.
Failure to do so may allow the machine to move
unexpectedly if a control lever or pedal is mistakenly
touched with a part of the body, possibly resulting in
personal injury or death.
d
CAUTION: Avoid possible injury while operating
height/tilt lever (1). When pushing down lever (1), do
not grab it. Fingers may be pinched between lever (1)
and the seat stand. Be sure to push on the upper face
of lever (1) by your palm.

Seat Height and Angle Adjustment

Seat height at both front and rear is adjusted in range of 60
mm (2.4 in) with 5 steps by using height tilt lever (1).
Push down lever (1): to adjust front part of the seat.
Pull up lever (1): to adjust rear part of the seat.

Console and Seat Fore-aft Adjustment

Operate console and seat slide lever (3) to adjust the seat
and both right and left consoles to the desired distance
from the travel pedals and levers. The adjustment range
for seat and console fore-aft is 160 mm (6.3 in) with 9 steps
every 20 mm (0.8 in).

Seat Fore-Aft Adjustment

Operate seat slide lever (3) to adjust the seat to the desired
distance from the travel pedals and levers. The adjustment
range for seat fore-aft is 200 mm (7.9 in) with 21 steps every
10 mm (0.4 in).

Backrest Adjustment

Pull up lever (4) to release backrest lock. Move backrest to
the desired position and release lever (4).
OPERATOR'S STATION
3
1-132
4
2 1
SS-955
MDAA-01-290