Siemens SENTRON VL Series System Manual page 263

Table 8- 49
The table below shows the format (19) "Control communication module outputs". The circuit
breaker can be switched on or off with this, for example.
Table 8- 50
as of firmware version V1.13.0 of the COM15
1
The table below shows the format (24) "position in frame". Data point 24 specifies the
position of the SENTRON WL in the guide frame.
Table 8- 51
3WL/3VL circuit breakers with communication capability - PROFIBUS
System Manual, 03/2011, A5E01051353-02
Format (18) "Control communication module"
Byte Bit
0 2
0 3
0 4
0 5
0 6
0 7
Format (19) "Control communication module outputs"
Byte Bit
0 0
0 1
0 2
0 3
0 4
0 5
0 6
0 7
Format (24) "Position in frame"
Byte Value
0 0
0 1
0 2
0 3
Deletes the maintenance counters
Deletes the min./max. temperatures
Deletes all min./max. values except temperature
Synchronizes the clock to xx:30:00.000
Deletes the contents of the trip log and event log
Revokes the disable on the DP address and sets the address to 126
Reset user output
Open circuit breaker
Close the circuit breaker
Switch user output mode to trip message
Status of user output mode
0
1
Read status of user output
Read status of user input (COM15 only)
Disconnected position
Connected position
Switch not available
Meaning
Meaning
Set user output
1
Trip is output
Actuated by user
Meaning
Test position
Data library
8.7 Formats
1
263