Display The Wifi Connections - NETGEAR WAX220 User Manual

Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220
Table 6. Wireless LAN Information - 5GHz section
Setting
Wireless Mode
Channel Bandwidth
Channel
Table 7. Statistics Access Point 2.4GHz/5GHz section
Setting
Profile
SSID
Security
VID
802.1Q
RX (Packets)
TX (Packets)

Display the WiFi connections

You can display the WiFi connections (the list of connected devices) on each radio.
To display the WiFi connections:
1. Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
Monitor the AP and its Network
Connections
Description
The WiFi mode, which is fixed at 802.11 ax/ac/n/a.
The WiFi channel bandwidth. For for information, see Manage the channel high
throughput mode on page 67.
The WiFi channel. For for information, see Manage the WiFi channels on page 68.
Description
The profile number from 1 to 4 for the user WiFi network.
The WiFi network name.
The type of WiFi security on the SSID.
The VLAN ID, if any, that is configured for the SSID.
Shows whether VLAN isolation is enabled.
The amount of packets in Bytes and the number of packets that is received on the
SSID.
The amount of packets in Bytes and the number of packets that is transmitted on the
SSID.
98 User Manual