Table of Contents
Advertisement
Insight Managed WiFi 6 AX3000 Access Point Model WAX615
-
Ethernet LLDP: The status of Ethernet LLDP feature (Enabled or Disabled).
-
Country / Region: The country or region in which the access point operates
or for which the access point is licensed.
-
Current Firmware Version: The version of the firmware that is running on
the access point.
-
Backup Firmware Version: The version of the backup firmware on the access
point.
-
Bootloader Version: The primary bootloader (U-Boot) version that is installed
on the access point.
-
Serial Number: The serial number of the access point.
-
Current Time: The current system time of the access point.
-
Uptime: The time since the access point was last restarted.
• AP Interface Status: A green icon indicates that the interface is in use. A gray
icon indicates that the interface is not in use.
• IPv4 Settings section: The following settings are displayed:
-
IPv4 Address: The IPv4 address of the access point.
-
Subnet Mask: The subnet mask of the access point.
-
Default Gateway: The default gateway for the access point.
-
DHCP Client: The status of DHCP client (Enabled or Disabled).
• Wireless Settings section: The following settings are displayed, with separate
columns for the 2.4 GHz and 5 GHz radios:
-
Antenna: The type of antenna (by default, 2x2).
-
Wireless Mode: The operating WiFi mode of the radio.
-
Channel / Frequency: The channel and frequency that are used by the radio.
Display the WiFi radio settings
To display the WiFi radio settings of the access point:
1. Launch a web browser from a computer that is connected to the same network as
the access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
Monitor the Access Point and the
Network
182
User Manual
Advertisement
Table of Contents
Troubleshooting
