Change The Country And Region Of Operation - NETGEAR WAX220 User Manual

Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220

Change the country and region of operation

After initial configuration, you can change the country and region of operation of the
AP.
In some countries, the router is sold with a preconfigured country or region setting and
you might not be able to change it.
WARNING: Make sure that the country is set to the location where the device is
operating. You are responsible for complying with the local, regional, and national
regulations that are set for channels, power levels, and frequency ranges.
WARNING: It might not be legal to operate the AP in a region other than the regions
listed in the menu. If your country or region is not listed, check with your local government
agency.
To change the country and region of operation of the AP:
1. Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
A login page displays.
If you do not know the IP address, see Find the IP address of the AP on page 24. For
more information about the management WiFi network, see Management WiFi
network on page 43.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see kb.netgear.com/000062980.
3. Enter the AP login password and click the LOGIN button.
The AP login password is the one that you specified the first time you logged in to
the AP. The password is case-sensitive.
The Dashboard page displays.
4. Select Management > Network > Wireless.
The page that displays shows the Wireless Settings section and other sections.
5. From the Country / Region menu, select the country and region in which the AP is
operating.
6. Click the Apply button.
Manage the WiFi Radio Settings 66 User Manual