Display The Wifi Connections - NETGEAR WAX214 User Manual

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
Table 10. Statistics Access Point 2.4GHz/5GHz section (Continued)
Setting
802.1Q
RX (Packets)
TX (Packets)

Display the WiFi connections

You can display the WiFi connections on each radio.
To display the WiFi connections:
1. Launch a web browser from a computer or mobile device that is directly connected
over WiFi to the access point or connected to the same network as the access point.
2. Enter the IP address that is assigned to the access point.
If you are directly connected to the "CONFIG-ONLY" SSID, you can enter
https://www.aplogin.net.
A login window displays.
If you do not know the IP address, see Find the IP address of the access point on
page 33. For more information about the "CONFIG-ONLY" SSID, see 2.4 GHz
management SSID on page 58.
If your browser does not display a login window but displays a security message and
does not let you proceed, see Log in to the access point after you complete the initial
log-in process on page 35.
3. Enter the access point local device password and click the Login button.
The local device password is the one that you specified. The password is
case-sensitive.
The Device Status page displays.
4. Under Overview, select Connections.
The page that displays shows the Connection List - 2.4GHz table and the Connection
List - 5GHz table.
Monitor the access point and its
Network Connections
Description
Shows whether VLAN isolation is enabled.
The amount of packets in Bytes and the number of packets that is received on the
SSID.
The amount of packets in Bytes and the number of packets that is transmitted on the
SSID.
116 User Manual