Change The Country Or Region Of Operation - NETGEAR WAC510 User Manual

Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual
The Dashboard page displays.
4. Select Management > Configuration > System > Basic.
The General page displays the basic system settings.
5. Select one of the following radio buttons:
• AP. The access point functions in AP mode. This is the default setting.
• Router. The access point functions in Router mode.
WARNING: The system mode changes and the access point is reset to factory
default settings with the exception of the IP address of the WAN PoE port, the host
name, the country of operation, and the time zone.
6. Click the Apply button.
A pop-up warning window opens.
7. Click the OK button.
The pop-up window closes and your settings are saved. The access point restarts in
the new system mode.

Change the country or region of operation

You can change the country or region in which the access point operates. Note the
following:
• Make sure that the country is set to the location where the device is operating. You
are responsible for complying with the local, regional, and national regulations that
are set for channels, power levels, and frequency ranges.
• It might not be legal to operate the access point in a country or region other than
those listed in the menu. If your country or region is not listed in the menu, you must
check with your local government agency or check the NETGEAR website for
information about which channels you can use.
To change the country or region of operation:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
Manage and Maintain the Access
Point
163 User Manual