Inspecting The Connection Port - VeriFone UX700 Installation Manual

NOTE
Inspecting the
Connection Port
To Connect the
Terminal Power
Supply
3
Carefully slide the SAM card into the slot, by aligning the card and carefully
sliding into the slot until fully inserted.
Figure 2 Installing SAM Card
The SAM card holders ensure that cards fit into the slots in only one way.
•
The rectangular symbols show the SAM card's notched corners are always visible.
•
These indicate which way the card notch should face before you insert the card into
the SAM slot.
The circular symbols indicate the SAM card slot numbers.
•
4
Install additional SAM cards in the available slots as necessary.
The device has dedicated input/output connectors: Ethernet, RS-232, USB-A,
USB-B and DC power.
The UX700 device can be powered from a PSU in the non-Verifone system or by
a Verifone Power supply. It can be connected using a 4pin or 6pin plug.
S

Inspecting the Connection Port

UX700 I G
NSTALLATION UIDE
ETUP
13