Table of Contents
Advertisement
pedestrian, motor vehicle and non-motor vehicle can be detected, and the picture of
the object (for pedestrian/non-motor vehicle/motor vehicle without license plate) or
license plate (for motor vehicle with license plate) can be captured. You can send alarm
signal to notify the surveillance center and upload the captured picture to FTP server.
Note:
Only certain camera models support the function.
Detection Configuration
Steps:
1. Select the detection type from the list. Vehicle Detection and Mixed-traffic
Detection are selectable.
Note:
Reboot the device to activate the new settings when switching the detection
type of road traffic.
2. Check the checkbox of Enable to enable the selected detection function.
3. Select the lane number in the corresponding dropdown list. Up to 4 lanes are
selectable.
4. Click and drag the lane line to set its position, or click and drag the line end to
adjust the length and angle of the line.
5. Adjust the zoom ratio of the camera so that the size of the vehicle in the image is
close to that of the red frame. Only the position of red frame is adjustable.
Note:
Only 1 license plate can be captured at one time for each lane.
6. Select a Province/State Abbreviation in the dropdown list when the attribution of
license plate cannot be recognized.
7. Set the Arming Schedule.
1) Click Arming Schedule to enter the arming schedule interface.
2) Click on the time bar and drag the mouse to select the time period. Click delete
or delete all to delete the configured schedule.
3) Move the mouse to the end of each day, a copy dialogue box pops up, and you
can copy the current settings to other days.
4) Click Save to save the settings.
Note:
The time of each period cannot be overlapped. Up to 8 periods can be
configured for each day.
Network Camera User Manual
164
Advertisement
Table of Contents
