Table of Contents
Advertisement
Steps:
Enter the Face Detection settings interface, Configuration > Event > Smart
1.
Event > Face Detection.
Check the Enable Face Detection checkbox to enable the function.
2.
Check the checkbox of Enable Dynamic Analysis for Face Detection, and then the
3.
detected face is marked with green rectangle on the live video.
Note:
To mark the detected face on the live video, go to Configuration > Local to
enable the Rules.
Click-and-drag the slider to set the detection sensitivity. The Sensitivity ranges
4.
from 1 to 5. The higher the value is, the more easily the face can be detected.
Click Arming Schedule to set the arming schedule. Refer to Task 2 Set the Arming
5.
Schedule for Motion Detection in 10.1.1 Configuring Motion Detection for
detailed steps.
Click Linkage Method to select the linkage methods for face detection. Refer to
6.
Task 3: Set the Linkage Method Taken for Motion Detection in 10.1.1 Configuring
Motion Detection.
Network Camera User Manual
134
Advertisement
Table of Contents
