Inogen Rove 6 User Manual page 22

Step Instruction
Check your concentrator's battery level
7.4.2
2.1 Once your concentrator has started up fully, the display light will turn off.
2.2 At this time, you will see a battery percentage appear on the screen where the 'please wait'
icon (
2.3 If the battery is low, connect your concentrator to an external power supply, as described in
step 2.4 or switch it out for a fully charged battery.
2.4 If the battery has been removed, go back to section 3.6, part 4, "charging your concentrator's
battery" for steps to re-charge the battery.
7.4.3 Set your concentrator's flow setting
3.1 The flow setting(s) are prescribed by your physi-
cian or clinician.
3.2 Use the + or – setting buttons to adjust to the
desired setting.
3.3 The current setting can be viewed on the display.
IMPORTANT: It is normal to hear a difference in sound
as you change the flow setting.
DO NOT set your concentrator to flow settings not
prescribed by your doctor.
©2022 Inogen, Inc. All rights reserved.
) was previously.
Page 22 of 356
The flow rate is prescribed by your
physician; it is a "dose" of oxygen.
Too high or too low a rate may
eventually lead to harm.
96-12100-01-01-A