Incorrect Installation - universalblue UAP1905-21 User Manual

interference.
Do not use the device with the
•
air outlet near the walls or cover
the outlet to avoid overheating.
Do not tilt or tilt the unit; if the
•
unit tilts, disconnect it and ask
your dealer for advice.
Do not spray the device with
•
insecticide or other chemicals,
as the plastic box may become
deformed.
If water enters the device,
•
turn it off and disconnect it
from the power supply as soon
as possible. Call the service
department to check and repair
if necessary.
PRODUCT FEATURES
The contents of the package will contain
the following elements
conditioner, duct assembly, window kit
and remote control), with this user manual
and the warranty card (see picture 01 on
page 4).
Note: The picture is for reference only. The
content may vary depending on the model.
1. Control panel
2. Wind guide bar
3. Remote control support
4. Air inlet
5. Cord storage
6. Air outlet
7. Caster
8. Dehumidication drainage nozzle
9. Filter handle
10. Drainage nozzle
11. Duct assembly
12. Window kit
13. Remote control
You can check the product features in table
01 on page 10.
INSTALLATION
(See picture 02 on pages 4 and 5).
Do not use the appliance in the bathroom
or other areas with humid environments.
To install the device correctly, please follow
the instructions below:
A. Screw the drain tube into the air outlet
behind the panel (counterclockwise).
B. Install the window kit following the
instructions below, depending on the
model purchased.
C. Place the device by the window. The
distance between the body and the walls
or other objects must be at least 50 cm.
(portable air
D. Insert the air exhaust hose into the
window sealing plate, adjust the width
of the window opening.The length of the
sealing plate is adjustable.
The flat end of the drain pipe must fit into
place and the pipe must not be turned at
an angle greater than 45 °. Please keep the
drainage pipe ventilation unobstructed.

INCORRECT INSTALLATION

(See picture 03 on page 5).
Before using the appliance,
keep it upright for at least 2
hours.
appliance, make sure that it is
always kept upright.
• The length of the drain pipe should be
280 ~ 1,500 mm. Do not use extension
tubes or replace with other tubes as it
may cause a malfunction.
• It is important to keep the duct
unlocked. Incorrect installation will
affect the the performance.
• Prevent the exhaust duct from bending.
• Make sure that air can flow through the
tube.
When moving
EN
the
25