Table of Contents
Advertisement
Available languages
Available languages
• Press buttons TIMER + FAN at the
same time.
• Sleep mode: speed air decrease its
intensity to the minimum and will
turn off automatically after 7 hours
approximately. To activate or deactivate
this function:
• Press buttons TIMER + UP at the
same time.
• Keep in mind that this mode will
not work with dehumidifier and fan
modes.
• Changing ºC to ºF: the appliance is in ºC
by default, but you can change it to ºF, or
inverse way:
• Press UP + DOWN buttons at the
same time.
REMOTE CONTROL
(See picture 07 on page 7).
22.
Timer button: press this button to
use timer. Timer can be used when
on or off. Use up and down buttons to
establish desired time. Selected time
(appears on the display of the remote
control) will flicker 5 times to confirm
established time.
23.
Swing button: press this button to
turn swing mode on or off.
24.
ºC/ºF button: press this button to
change from ºC to ºF, or inverse way.
25.
Up button: press it to increase
temperature or timer time.
26.
Mode button: press this button to
select desired mode, cool, fan, dry or
heat.
27.
Down button: press it to decrease
temperature or timer time.
28.
Power button: to turn the appliance
on or off.
29.
Fan button: press it to establish air
speed, low, medium or high.
COOLING MODE
• When the device is switched on, this
mode will automatically be selected,
but it can also be selected on the control
panel. The indicator light in this mode
will light up.
• In this case, the device will expel
cold air and will operate in the air
conditioning mode.
• Press the corresponding buttons to
increase/decrease
(from 16º to 30º).
• Press the speed key to select the
appropriate speed.
FAN MODE
• Select this mode via the device's control
panel or with the remote control, the
indicator light in this mode will light
up.
• In this case the device will only expel
air and will operate in the fan mode.
• Select the desired speed (High/Low).
• The temperature cannot be selected in
this mode.
DRY MODE/ DEHUMIDIFYING MODE
• Select this mode via the control panel
of the device or with the remote control,
the indicator light in this mode will
light
• This mode has the particularity of
regulating the temperature of the
room automatically and acting as a
dehumidifier.
• Remove the water plug (see right),
insert one end of the pipe into the drain
hole and the other end into the water
tank.
• If the temperature is equal to or greater
than 17 ºC (or 62 ° F), the compressor
turns on. Thereafter, it is controlled
according to the following rules: the
compressor is turned off when Ta ≤
15° C (or 59° F) and restarted when the
temperature rises to Ta ≥ 17° C.
• In this case, the speed cannot be
adjusted and it always works at low
speed by default.
• The temperature cannot be selected in
this mode either.
TIMER MODE
• When the device is on standby, press
EN
the
temperature
27
Advertisement
Table of Contents
