Air Filter Cleaning; Environmental Information - universalblue UAP1905-21 User Manual

Hide thumbs Also See for UAP1905-21:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
NOTE:
in
the
dehumidifying
function
appliance, continuous drainage can also be
carried out as follows:
• Remove the upper water outlet plug to
drain the water.
• Place the hose in the water outlet.
• Place the other end of the hose in a
bucket or container to drain the water.
To avoid accidents caused by
electric shock, make sure that
no power is supplied to the unit
before starting maintenance or
repair.

AIR FILTER CLEANING

If the air filter is blocked by the
accumulation of a large amount of dust,
the volume of the air flow will be reduced.
Clean the filter once every two weeks.
(See picture 10 (O and P) on page 8).
40.
Retaining screw
41.
Wedging block
42.
Wedging block
• To clean upper filter or EVA filter, pull
slightly to take the wedging block out
and unscrew the retaining screws.
Wash the EVA filter with neutral
detergent and hot water (around 40 ° C
or 104 ° F)
• To clean lower
gently pull the wedging block and
immerse the filter in hot water and
neutron soap.
• Rinse the filter detergent and let it dry
completely in a shady place.
• Return the air filters to their original
place.
AIR CONDITIONING CLEANING
Switch off the appliance before cleaning.
Make sure there is no power to the unit
before beginning to maintain or repair,
prevent accident caused by elec. shock.
30
case
of
using
or
the
cold
filter or CONE filter,
the
Do not use chemical solvents
(such as benzene or alcohol) to
clean the surface of the unit;
doing so will scratch, damage,
and even deform the entire
case. Clean the surface of the
unit with a damp cloth. Then dry with a
cloth or similar.
BEFORE YOU PUT IT INTO OPERATION
• Check if the air inlets and outlets of the
unit are blocked.
• Check that the partition plate stop and
the base stop are installed correctly.
• Before turning the unit on, make sure
the air filter is in the correct position.
If the equipment is operated without
the air filter, dust and other objects
will cause the air conditioning to
malfunction.
IF IT'S GOING TO BE UNUSED FOR A
WHILE
• Turn off the air conditioner and
disconnect it from the power supply.
• Maintain the air filter and other parts
correctly.
• Open the partition plate stop and the
base stop for draining water from the
partition plate and the base. Then run
the unit in fan mode for half an hour to
ensure that the divider plate and base
are dry.
• Use a plastic sheet to cover the unit to
prevent dust or dirt from entering the
unit.

ENVIRONMENTAL INFORMATION

disposed of correctly, you will help prevent
any possible damage to the environment
This appliance is labelled in
compliance with European
directive 2012/19/EU for Waste
Electrical
and
Equipment
(WEEE).
ensuring that this appliance is
Electronic
By

Advertisement

Table of Contents
loading

Table of Contents