Incorrect Installation; Window Kit Installation - universalblue UAP1903-21 User Manual

ENGLISH
air outlet near the walls or cover
the outlet to avoid overheating.
Do not tilt or tilt the unit; if the
•
unit tilts, disconnect it and ask
your dealer for advice.
Do not spray the device with
•
insecticide or other chemicals,
as the plastic box may become
deformed.
If water enters the device,
•
turn it off and disconnect it
from the power supply as soon
as possible. Call the service
department to check and repair
if necessary.
PRODUCT FEATURES
The contents of the package will contain
the following elements
conditioner, duct assembly, window kit
and remote control), with this user manual
and the warranty card. See picture 01 on
page 4.
Note: The picture is for reference only. The
content may vary depending on the model.
1. Control panel
2. Air inlet grille (Upper)
3. Wind guide bar
4. Handle
5. Cord storage
6. Drainage nozzle
7. Air inlet grille (Lower)
8. Duct assembly
9. Window kit
10. Remote control
You can check the product features in table
01 on page 9.
INSTALLATION
(See picture 02 on pages 4 and 5).
• Place the appliance in a dry, horizontal
22

INCORRECT INSTALLATION

(See picture 03 on page 5).
(portable air

WINDOW KIT INSTALLATION

Installing the window kit
(See picture 04(E) on page 6).
OPTIONAL WINDOW SEALING KIT
(See picture 04(F) on page 6).
If your kit uses screws (See picture 04 (G)
on page 6):
If your kit uses clips (See picture 04(H) on
page 6):
position near the window and maintain
a safety distance of at least 50 cm
around the appliance.
• Turn the drainage tube at the air outlet
behind the panel (counterclockwise).
• Screw the drainage tube into the air
outlet behind the panel (counter-
clockwise).
• Insert the air release hose into the
window sealing plate, adjust the width
of the window opening so that the
window can be matched to the sealing
plate correctly; the length of the sealing
plate is adjustable; and screw it on.
• It is important to keep the duct
unblocked. A
will affect to the performance of your
appliance.
• Avoid the duct blending at any point
• Ensure the air flow can fluid correctly
11. Conector
12. Exhaust air duct
13. Flat nozzle
• Measure the size of the window;
• Adjust the length of the plate according
to the size of the window.
• Fix the plate with a screw
• Measure the size of the window;
• Adjust the length of the plate according
to the size of the window;
• Block the plate.
correct installation