SPX SPIDAR NIC-500s Operation Manual page 98

Appendix C: Calculating GPS Latency
10. Close LineView. Now you should see all of the observations clustered near the center of the
flower pattern in MapView.
11. Run the Project Report under File > Report > Project Report, make a new folder called
0s_latency and save the report inside.
12. Go to Tools > GPS > Latency and set it to 1 second, click OK.
13. Run the Project Report again under File > Report > Project Report, make a new folder
called 1s_latency and save the report inside.
14. Open a new spreadsheet in Excel. Copy and paste the UTM coordinates from the two
project reports into the columns of the new spreadsheet.
90