SPX SPIDAR NIC-500s Operation Manual page 74

SPIDAR SDK
Figure 5-12: Network Settings tab
5.3.2 Data Collection with Pulse Trigger
When the Trigger Mode setting is set to "Pulse" (see 5.4.2), a device that sends out an
electronic pulse can be used to trigger data collection. The SPIDAR SDK enabled NIC-500
collects a GPR trace on every pulse. This is done using the Link In port 15-socket D-connector
shown in Figure 5-13.
Figure 5-13: NIC-500 showing the Link In port
The Link In port can also be used to control the power to the NIC-500 from your device,
mimicking a press of the power button.
The details of this port are described in Appendix E.
66